I am now getting round to the fiddly detail bits. One of these is fitting notched bales between the top the main interior wall and the roof (the bales have to be notched to allow for a purlin) and also putting bales in place above the doorways. It was good to return, one last time to ‘straw work’ athough cutting the notch with a chainsaw meant becoming swamped in loose straw. It also reinforced that by far and away the best tool for cutting or shaping straw is an electric chainsaw (not a petrol one because the straw gets in the air intake and it overheats).
I have also been finishing off the clay around the windows and door frames – using a ‘cobby’ mixture of straw and clay. I want to plaster right up to the window frames, rather than put decorative wooden frames and window ledges in place. I think this sets-off the window frames to best effect, but it does mean plastering over the window sub-frames as well as sticking clay ‘upside down’ to the sub-frame above the windows. To do this I covered the wood in a flour, water and clay paste to give it maximum adhesion. This appears to have worked – although for the final coat I will also stretch hessian or fibre-glass mesh around curve, both to stop cracks developing over the join and also to hold the upside down plaster in place should it feel like falling-off. The job feels a little like being a housemartin, sticking clay and straw to the underside of eaves – and the resilience of their nests gives you some confidence that the clay, with added flour paste, will be sticky enough.